Ski Doo Key 1998 Sea-Doo RX Issue: No Beep When Lanyard Is Attached, And It Won't Start?

Sea-Doo RX issue: No beep when lanyard is attached, and it won't start? - ski doo key 1998

I have a 2000 Sea-Doo RX was hoping you could help me. Is no longer used after one year, the battery is empty and free of charge. I loaded it replaced by a new battery, and went on a jet ski to start. But when I use the key in the chain of command bits / Post, which Sea-Doo, not the usual two beeps (if the device LCD screen to) the time display. When I pressed the red start / stop-start button, nothing happens. Even after cleaning the contacts in both of my keys, I could not play the Sea-Doo, when a button is placed.

I have tried self-test point, and that's what happened: After five presses the start button, there was a short beep followed by a long beep. Then, one of three things hAppenzell:

1. Without going into the lanyard, I press the start button: Ski beeps twice
2. I have a safety rope, then press the power button: Ski beeps twice (the same as pressing the button without the safety rope)
3. Sometimes, however, when out on the cable, and press the start button, the beep-beeps Resort

What these results?

Another thing that was tried shorting / bypass the starter relay in the electric field behind him. This led back to the engine. Also, I checked all the fuses in the MPEM module and all were very good. I could find, I checked the only fuse back into the electric field and also well done.

I think forget the Sea-Doo, "" the key if the battery was dead for more thanMonths and no longer recognizes their codes. The service representative at my local dealer told me by phone that my starter relay is probably broken, but I'm not with him, because it is a fundamental problem, I think.
I hope someone can help me?? Any advice would be very grateful.